HPM RC Power Boats

There are no items in your cart.

 
 

HPM-WO008 ALI GROMMETS 8mm

HPM-WO008 ALI GROMMETS 8mm Image
Detail Image

BULKHEAD FITTING:
Aliminium Grommets a simple and clean way for feeding your Silicon Tubing through the boat transom.
These are used so you can run one piece of tubing from the water pickup to the motor or esc in your boat. These are simple to install, drill a hole and use silicon or epoxy to hold it in. No possibility of tube falling of a nipple.

2 per pack
Inside ID: 8mm
Ourside ID: 9mm

INSTALLATION:
Installation note: First cut a 45 degree angle on the tubing. Then apply a thin coating of oil on the outside of the tubing. Start the tubing into the hole, then pull the tubing through the grommet from the opposite side with a pair of pliers.

Your Price:NZ$3.90
41
Choose from 1 to 10: